搜索资源列表
Dimmer_m32
- This Temperature PID regulator for Tamman ovens. Temperature is measured by thermocouple via lm358 - > Atmega s ADC and regulated over triac. All data is sent via RS232 connection on PC and controlled by LabView.-This is Temperature PID regulator
controltriac
- control triac (220 AC) by pic microcontroller
AVRTemperatureControlSystem
- 基于 AVR 单片机的水温自动控制系统 摘要: 本系统以 ATMEGA16 单片机作为系统的检测和控制核心，采用温度传感器 AD590实现0—100℃温度范围内的实时温度采集，通过双向可控硅 BT136 控制电热杯对系统进行加热，利用继电器控制半导体制冷片对系统进行散热。通过一线键盘实现对任意温度值进行设定并对模糊 PID 参数的调整，液晶 LCD1602 实时更新显示当前温度测量值与键盘设定温度值。利用模糊 PID 算法，通过调功法对水温系统进行控制,实现在 0—100℃范围内任
Microcontrollers and Triacs Easily Connected
- Triac control using 8051 compatible controller, with C source
documenta??o do hardware
- One method of controlling power to AC circuits uses a TRIAC to turn the power on and off at precisely timed intervals that are synchronized with the AC signal. This method is called AC phase control. It is the method used in many light dimmer and hea
PID_FrontEnd_v03
- Using an Arduino microcontroller with some simple circuitry, we can monitor the AC wave to determine the proper time to turn the power on and off with the TRIAC (a 10kOhm pull-up resistor is needed at the H11AA1 pin 5). The circuit I used to do this
LGR_ZETA2
- The circuit consists of an opto-isolated zero-crossing detector and an opto-isolated trigger circuit for the TRIAC. The opto-isolators are necessary to keep the low voltage signal circuits away from the power circuits and provide an appropriate level
ArduinoKRUPS
- Keeping alive a KRUPS cofee maker with Arduino WARN!! does not has PID to control temperature The LED flashing sometimes fail NTC pin to +5V, Another pin to A0, A0 (PullDown resistor) to Gnd of 22000Ohms (22K - orange,orange,orange) For led
triac_pulse_lcd
- Control triac for temperature regulation ir
BTA41-600B
- BTA41-600B TRIAC Manual