搜索资源列表
enc28j60
- enc28j60的驱动程序 Microchip ENC28J60 Ethernet Interface Driver Chip type : ATMEGA88 with ENC28J60
USART
- ATmega88 串口连接原理图 一个按键，2个Led
Rs232Test
- ATmega88 RS232的通讯程序演示，该程序主要功能是发送3组字符串。-ATmega88 RS232 communication program demonstrates, the program main function is to send three set of strings.
LedFlash3
- 该程序主要是ATmega88 A/D转换程序的演示。当通道ADC0(PC0)上的电压大于2.5V时，LED开始闪烁！-The program is mainly ATmega88 A/D conversion process of the presentation. When the channel ADC0 (PC0) is greater than 2.5V when the voltage, LED start blinking!
LedFlash2
- 熟悉ATmega88 定时器的使用，进一步了解AVR单片机定时器的使用方法！-ATmega88 timers are familiar with the use of a better understanding of AVR microcontroller to use the timer!
Tesla_Meter_R1
- This a Tesla meter based on the microcontroller ATmega88. A Micronas analog Hall sensor HAL 815 is used. Project is done with IAR compiler. A 20x4 LC-display is used for output-This is a Tesla meter based on the microcontroller ATmega88. A Micronas a
bootcfg.h
- AvrUB config 4 ATMega88 8MHz BOOTSZ=3
eeennc28j60n
- enc28j60的驱动driver程序源码 Microchip ENC28J60 Ethernet Inteerface Driver Chip type : ATMEGA88 with ENC28J60 可直接使用。 -enc28j60 driver driver program source code Microchip The ENC28J60 the Ethernet Inteerface Driver Chip, the type: the ATMEGA88 the with Th
rollerlight-1.2
- http://vk.com/podsvetka.cheb ATmega88 rollerlight firmware
avr444
- Robust sensorless commutation control. External speed reference. Overcurrent detection/protection. Basic speed controller included. Full source code in C. Source code can be adapted to a new motor by changing parameters. Several I/O pins
usbasp.2009-02-28.tar
- usbasp.固件，驱动，更新于2009年(USBasp is a USB in-circuit programmer for Atmel AVR controllers. It simply consists of an ATMega88 or an ATMega8 and a couple of passive components. The programmer uses a firmware-only USB driver, no special USB controller is ne