搜索资源列表
minibuttonsandled
- 关于led流水灯与按键结合的程序，四个按键控制led流水灯-Led lights and buttons on the water of the combination of the program, four key water control led lights
arm_led_interrupt
- 在s3c6410上实现采用中断按键控制led灯点亮，裸板驱动(c语言)-to bright the led with c throght loop
cgi_led
- 实现了led灯的远程控制!这是其代码实现过程-led realize
led_driver
- led灯的驱动，仅仅实现了对其的亮灭控制。-led control
2intauart
- LPC2000 中断和串口程序，ARM开启两个中断源Eint1与Eint2，分别用一个按钮来控制。在没有中断的时候两个LED都缓慢闪烁，当任何一个中断被出发的时候，对应的LED会急促闪烁，逐渐回复正常。 此外，使用一个串口来发送当前状态，在无中断的时候发送正常状态报告，当有中断的时候，串口发送中断源。 -lpc2000 interrupt and uart proc，tow interrupt resorces and seperately control tow led2 and se
mini2440lightLED
- ARM开发板mini2440，通过来按键控制开发板上的LED亮与灭-Mini2440 ARM development board, development board through to the key control LED on and off
s5pc100
- 利用平台设备机制，对s5pc100实现按键对Led灯的控制，按下点亮，松开熄灭-Use platform equipment mechanism to realize s5pc100 buttons on the control of Led lights, press the light, loosen put out
leds-gpio
- 控制led灯的驱动程序，也就是流水灯，程序中有4个led灯，依次按照先后顺序亮与灭-Control driver led lights, light water, 4 led lights in the program, followed in accordance with the sequence of bright and off
OK6410-key_led
- OK6410按键控制LED驱动源码及应用程序-The OK6410 buttons control the LED driver source code
key-and-led
- stm32的可用驱动模板，通过简单的按键控制流水灯来实现-the stm32 available driver templates, through the simple push-button control of light water
6410-Digital-LED--for-linux
- 在Linux下写的74HC595的驱动程序，用于控制数码管-Write the 74HC595 driver under Linux, used to control digital tube
LED-linux
- 并口驱动,所有端口与电路板上管脚相连，向并口写数据可以控制并口电平-Parallel Drive Register the parallel LED device with parport
LED
- RM9 2400开发板LED灯中断控制源码-failed to translate
LED
- linux系统下LED灯采取中断形式GPIO控制-in linux LED lights take the form of an interrupt GPIO control
LED
- ok6410 键控LED 按键控制LED的亮-ok6410 LED
led
- 简单LED驱动，是用来控制天嵌2440开发板的-simple LED driver
led
- 驱动程序，在ARM linux上控制led亮和灭-control led light
LED12Control
- 控制led控制卡,P3.75,12扫的点阵屏幕-Control of the LED control card, P3.75,12 and dot matrix screen
LED
- 点亮P1口的一个LED灯 该程序是单片机学习中最简单最基础的， 通过程序了解如何控制端口的高低电平-A leds light up P1 mouth The program is the basis of a microcontroller learning one of the most simple, Through the application to know how to control the high and low level of port
plat
- 平台总线程序，包含测试程序，可实现简单的LED控制等功能-LED plat program