搜索资源列表
okada_matlab
- okada模型是地震、地壳形变、断层等反演中常用的且重要的反演模型。程序包基于MATLAB开发，功能齐全、有数据。-okada model of an earthquake, crustal deformation, fault and other commonly used and important inversion of the inversion model. Package based on MATLAB development, full-featured, with the da
GAbp
- 遗传神经网络的模式识别算法,可以用于设备的故障诊断-Genetic neural network pattern recognition algorithm, can be used for equipment fault diagnosis
buduichen
- 电力系统短路计算程序，用来进行不对称短路计算。-Power system short-circuit calculation procedures used for asymmetric short-circuit calculation.
bearingroll
- 轴承滚动体故障诊断，故障设置为滚动体局部剥落，故障特征频率为外环通过频率或倍频理论计算得到218.98Hz.-Rolling bearing fault diagnosis, fault set rolling local spalling, the failure characteristic frequency for the outer ring through the frequency or frequency theoretical calculations 218.98Hz.
KPCA
- 基于KPCA（核主元分析）发对TE模型进行故障诊断和辨识-Based on KPCA (KPCA) TE model made of fault diagnosis and identification
GA
- matlab中编的基于遗传算法的转子故障特征选择的小程序，新手程度，仅供参考-matlab in the series based on genetic algorithm rotor fault feature selection of small programs, novice level, for reference only
location0506
- 输电线路双端不同步故障测距程序，matlab的程序，利用两端数据计算故障距离-Two terminal lines are not synchronized fault location procedure, matlab procedures, the use of both ends of the data to calculate the fault distance
fault-analysis
- Fault analysis program in matlab. Consists of codes for all kind of faults
MATLAB-motor-simulation
- Matlab 各种电动机的仿真，以及在运行中出现状况是的故障仿真，一共50个-Matlab simulation of various motor, as well as in operation in the condition of fault simulation
synchonous
- 基于matlab simulink的同步发电机仿真模型，可以直接运行观察同步发电机运行状态，可以给不同的故障观察故障下的同步发电机运行状态-Matlab simulink simulation model based on synchronous generator can be run directly observed synchronous generator running, you can give a different operating state of synchronous
Inverted-Pendulum-Fault-detection
- matlab编写的等价空间故障诊断方法，倒立摆仿真程序-matlab prepared space equivalent fault diagnosis method, inverted pendulum simulation program
position-the-fault
- 电力电缆故障测距，定位电力电缆故障的，方便检修，适用于matlab环境。-to position the fault of a power cable,to serve for the examine and maintain of the power cable.
untitled1
- 是一个matlab中的power system 中搭建的一个模型。可以仿真35KV电力系统线路发单项短路故障、两项短路故障、和三项短路故障的短路电流电压波形。-This is a model of building a matlab power in system. Simulation of 35kV Power line system billing short-circuit fault, two short circuit fault, and three short circuit f
Duval
- This code is developed in MATLAB and is a GUI for the Duvel triangle which is used to determine the fault types in the transformers. It is easy to use and provide more information than others.
danduan.emt
- 考虑噪声和弱行波的对测量影响的配电网行波测距。在PSCAD上搭建模型仿真获得数据导入MATLAB进行小波分析，最终实现故障测距，精度达到102m，-Consider the impact on the measurement of the distribution network traveling wave noise and weak traveling wave. Built on the model simulation PSCAD get data into MATLAB wavele
line_xingbo
- 基于Matlab/Simulink的输电线路故障行波仿真模型，模型是由3个电源和4段分布参数输电线构成的环形电网。-Based on the Matlab/Simulink of the transmission line fault traveling wave simulation model, the model is composed of 3 power supply and 4 section of the distribution parameters of the ring po
AC_microgrid_fault
- 利用Matlab建立主电网发生故障时的交流微电网模型。交流微网运行在480V，从120 kV电网交流输入降压11kV然后走到480V。故障发生在t 10秒。-Using Matlab to establish the AC micro grid model of the fault of the main power grid. AC microgrid runs in 480V, 120 kV AC input to buck 11 kV and then go to 480V. Failu
simulink2
- 在这项研究工作中主要集中开发基于混合光伏风电系统的智能控制和电网整合以及电池存储系统。电网整合混合式PV-Wind与基于智能控制器的电池管理系统[BMS]已经在Matlab中开发了一个仿真模型，并分析了正常条件下的系统性能。同样的系统已经用UPFC模拟，并分析了不同故障条件下的系统性能。-In this research work focused on the development of smart grid integration and control, and battery stora
qwe
- 无穷大功率电源供电系统 1. 理解无穷大功率电源供电系统的特点与故障特征； 2. 学会用MATLAB/Simulink进行无穷大功率电源供电系统的建模与仿真； 3. 学会Simulink仿真模型参数的设置； 4. 学会Simulink仿真结果的处理。 -Infinite power supply system 1 understand the characteristics and fault features of the infinite power supply s
选线仿真模型
- 小电流系统接地选线仿真模型及稳态零序功率方向法仿真算法(Simulation model of grounding fault location for small current system and simulation algorithm of steady zero sequence power direction method)