搜索资源列表
PWM-motor
- 采用51单片机PWM方式控制直流电机转速，闭环系统，转速采用数码管显示，采用PROTEUS仿真-With 51 single-chip PWM control of DC motor speed, closed-loop system, the use of digital speed display, using PROTEUS simulation
LZF
- 用51单片机进行电机转速的测定，显示到屏幕上-Carried out with 51 single-chip motor speed measurement, indicating that the screen
step
- 51单片机控制四相步进电机,单片机来控制此步进电机，则只需分别依次给四线一定时间的脉冲电流，电机便可连续转动起来。通过改变脉冲电流的时间间隔，就可以实现对转速的控制；通过改变给四线脉冲电流的顺序，则可实现对转向的控制。-51 single-chip four-phase stepper motor control, single-chip microcomputer to control the stepper motor, then were followed by only a certai
dianjikekongguikongzhi
- 用51单片机来控制可控硅的截止和导通，从而控制直流电机的转速和方向。-With 51 single-chip microcomputer to control the cut-off thyristor and conduction to control DC motor speed and direction.
zhiliudianjitiaosu
- 51单片机控制直流电机的启停，正传，发转，调节pwm占空比控制电机转速。-51 MCU controlled DC motor start and stop, True Story, hair switch, regulating the duty cycle pwm control motor speed.
MCU_measuring_motor
- 51单片机测量电机转速，利用计数脉冲数显示到汉字液晶屏上面。脉冲是由对管扫描码盘产生的-51 MCU measuring motor speed using pulse-counting the number of
Moter
- 步进电机转速控制程序：可以通过电位器来精确调节电机的转速的-Stepper motor speed control program: can potentiometer to fine tune the motor speed
motor_1
- 基于51单片机的直流电机调速控制器，可以控制直流电机的转速及方向。-51 Microcontroller based DC motor speed controller that can control DC motor speed and direction.
wenkongdianshan
- 自动温度控制电扇系统，根据温度控制电机转速，51单片机仿真图和程序。-Automatic temperature control fan system, motor speed according to temperature control, 51 MCU plans and procedures.
bujin3
- 1、以51单片机作为核心器件，扩展A/D、D/A转换芯片，经过A/D送入处理器，数据处理后，控制信号输出，经过D/A转换，控制直流电机转速调节。 2、掌握步进电动机控制系统的硬件设计方法。进一步学习编制步进电动机驱动程序的软件设计方法。编制程序，控制步进电动机的运转速度及旋转方向。-bujindianji
can
- 51单片机，SJA1000CAN控制器上CAN发送接收数据程序。通过USBCAN发送控制报文，控制直流电机转速，经调试好使。-51 single-chip, SJA1000CAN CAN controller program sending and receiving data. Control packets sent by USBCAN, DC motor speed control, so that by debugging.
WDZ
- 基于51单片机，用红外遥控器控制电机正反转，并改变转速快慢。(Based on 51 single-chip, with infrared remote control motor positive and negative, and change the speed speed.)
实验六
- 51单片机 旋翼平衡控制系统实验源程序。旋翼系统由12V直流电机及平衡配重系统构成，平衡位置由磁钢及线性霍尔传感器SS49E构成。位置信号由SS49E输出，经过A/D采样，得到位置信息，通过控制算法，得到输出控制信号，经D/A输出控制电机所加电压，从而控制电机转速使得旋翼系统平衡。(51 microcontroller rotor balance control system experimental source)
红外控制步进电机
- 用红外控制步进电机转动角度，并且用LCD显示，采用51单片机控制，转速误差在1%之内(With infrared control stepper motor rotation angle, and with LCD display, using 51 single-chip microcomputer control, speed error is within 1%)
电机转速测量与PWM控制
- 基于51单片机的c语言程序 电机转速测量与PWM控制(C language program based on 51 singlechip motor speed measurement and PWM control)
直流电机红外控制
- 红外遥控器通过51单片机来控制直流电机转速(Control of motor speed by infrared remote control)
51单片机pwm按键控制直流电机加减速源程序
- 51单片机实现温控风扇的设计，通过温度的变化来控制风扇的转速，通过按键的控制来改变温度的上下线。(51 single chip microcomputer realizes the design of the temperature control fan. The rotation speed of the fan is controlled by the temperature change, and the upper and lower temperature line is chang
51单片机播放音乐
- 51单片机播放音乐的同时根据音乐音调控制电机转速
直流电机测速
- 使用51单片机，通过按键控制直流电机的转速并测量直流电机的转速，并实时用数码管显示出来。(51 traffic lights, time is 60 seconds, control the intersection of traffic, there are digital tube display, the program is easy to change.)