This file is distributed in the hope that it will be useful, but WITHOUT

WARRANTY OF ANY KIND.



Author(s): Ole Saether



DEscr iptION:



This example should be used together with ex2a-tx433.asm. One nRF9E5

evaluation board (receiver) should be programmed with the hex-file generated

from assembling this file and the other evaluation board (transmitter)

programmed with the hex-file generated from assembling ex2a-tx433.asm.



All switches on the DIP-swith S206 on the receiver must be set to the "on"

position and all switches on the DIP-swith S205 on the transmitter must be

set to the "on" position.



When one of the switched SW1-SW4 on the transmitter is pressed the

corresponding LED on the receiver is turned on.



The functionality is the same as in ex2c-rx.c.-　This file is distributed in the hope that it will be useful, but WITHOUT

　WARRANTY OF ANY KIND.



　Author(s): Ole Saether



　DEscr iptION:



　　This example should be used together with ex2a-tx433.asm. One nRF9E5

　　evaluation board (receiver) should be programmed with the hex-file generated

　　from assembling this file and the other evaluation board (transmitter)

　　programmed with the hex-file generated from assembling ex2a-tx433.asm.



　　All switches on the DIP-swith S206 on the receiver must be set to the "on"

　　position and all switches on the DIP-swith S205 on the transmitter must be

　　set to the "on" position.



　　When one of the switched SW1-SW4 on the transmitter is pressed the

　　corresponding LED on the receiver is turned on.



　　The functionality is the same as in ex2c-rx.c.