搜索资源列表
软件法实现7段 SVPWM
- 利用TMS320LF240x实现SVPWM算法的程序 下面给出了利用TMS320LF2407实现SVPWM算法的一个应用程序。在该程序中,我们假设有200个电压矢量Uout 平均分布在电角度为2π的范围内,通过改变SVPWM的调制周期T可以改变输出的3相正弦波的频率。 源程序代码-use TMS320LF240x SVPWM algorithm to achieve the following procedure is the use of TMS320LF2407 SVPWM algo
audiodma
- DSP音频处理示例The benefits of real-time analysis provided by DSP/BIOS are often required in programs that were engineered without it. When the program is not built from the ground up using the DSP/BIOS kernel and real-time analysis features, the lack
tf3
- 这是一个时频分析中关于gabor变换的程序,此程序分离频率的效果不错。 Gabor变换: 式中a,b为常数,a代表栅格的时间长度,b代表栅格的频率长度 式中的 是一维信号x(t)的展开系数,h(t)是一母函数,展开 基函数是h(t)由作移位和调制生成的, - This in a time frequency analysis about the gabor transformation procedure, this procedure separation freq
fft_fxp16
- TigerSharc TS201 32-bit floating point FFT routine -TigerSharc TS-201 32-bit floating point FF T routine
zarlink_dvb-t
- zarlink Dvb-t demod + tuner datasceet-zarlink Dvb-t demod tuner datasceet
28BIOS_lattest
- In this example, a task created with the configuration tool goes in a loop forever in which it spends parts of the time doing atomic operation-In this example, a task created with the configuration tool goes forever in a loop in which it spends parts
pmsm28x
- T TI公司28XDSP控制永磁同步电机PMSM-T TI 28XDSP control of permanent magnet synchronous motor PMSM
feedbacktime
- t transistor has the characteristics of components of the sensor real-time measurement of voltage and current signals through, obtained quality factor correction circuit for the feedback and the feedback time, IBM used the feedback field effect trans
dspwjbs
- 无级 变 速 器又称CVT( continuouslyv ariable transmission,CV T),其速比可以连续变化,使用 这种变速器,可有效地利用发动机的性能,使发动 机与传动系得到最佳的匹配,从而提高汽车的燃 油经济性和动力性。无级变速器是迄今为止最理 想的变速器,它代表着当今汽车变速器发展的水 平和方向。
t
- 完成cnc系统的T曲线控制,较好的完成数控加工
dspjtag
- J T AG 接口插座与DSP芯片的距离:为了保证JTAG信号不受干扰,需 要注意两者之间的距离不超过六英寸(15甲24厘米),超过这个距离,就需要在中 间加缓冲芯片。本设计中使用了244作为缓冲芯片,但其原因不是由于器件之间 距离过长,而是考虑到仿真器工作在5V电压,DSP引脚为3.3V,为了电平兼容 性而进行的电压转换功能。
DSP
- 该文设计的 D S P最小系统可应用于教学,本科生通过在此硬件平台上实现 F S K的调 制及 F I R滤波器的实现两个实验,可以掌握 D S P硬件调试方法,增加对 D S P开发过程,以及 D S P基本 算 法 实现 的理 解。文 中所 设计 的 D S P最 小 系统 由 T I公 司 的定 点 D S P芯 片 T MS 3 2 0 V C 5 4 0 2及其相关电源和时钟电路 、片外扩展存储 器、A / D、D / A、标准 U A R T接 口构成
FLASH在系统编程和DSP并行引导的C语言实现
- 介绍了一种在DSP 仿真环境下,采用C 语言对FLA SH 进行在系统编程( ISP)的 方法,同时介绍了TM S320VC5402 的Boo t loader 原理,给出了DSP 的并行FLA SH 引导功能实现 方案,并且给出了一个简单的测试实例-introduced a DSP simulation environment, using the C language for the FLA SH-system programming (ISP), TM also introduced th
TI DSP的网络开发包NDK样本工程
- TI DSP的网络开发包NDK样本工程,可用与学习嵌入式的TCP/IP学习和应用.,TI DSP development kit NDK network sample projects, and learning can be used embedded TCP/IP learning and application.
jpeg_loopback.rar
- DSP的一个应用程序,在上面可以完成视频的采集和显示功能,用户可以将图象处理代码加入即可,这个程序实际上就是一个对VP口等外设进行配置的底层驱动程序,err
TCPIP.rar
- 2812 TCP/IP 非常有用的啊,基于CS8900,2812 TCP/IP is very useful, ah, based on the CS8900
dm365_tests.tar
- CCS下对TI DM365的板级调试及测试程序。-This is the board debug and test program for TI DM365 in CCS.
DSP
- 1.利用傅立叶级数展开的方法,自由生成所需的x(t); 2.通过选择不同的采样间隔T(分别选T>或<1/2fc),从x(t)获得相应的x(n)(作出x(n)图形); 3.对获得的不同x(n)分别作傅立叶变换,分析其频率响应特性4.利用巴特沃思、切比雪夫或椭圆滤波器设计数字滤波器(滤波特性自定),要求通过改变滤波器参数或特性(低通、高通、带通或带阻)设计至少两种数字滤波器,分析所设计滤波器并对上述给出的不同x(n)分别进行滤波; 5.利用窗函数设计法或频率采样法设计数字滤波
T-REC-G.723.1-200605-I!!SOFT-ZST-E
- ITU.T s G.723.1 fixed point encoder/decoder-ITU.T s G.723.1 fixed point encoder/decoder...
T-speed
- 利用CCS编写的DSP工程,代码主要实现的功能就是对一段位移进行T型速度规划,在板子上跑拥有很不错的速度和位移响应曲线-Use of CCS projects written in DSP code main function is to carry out some T-displacement velocity planning on running board has very good velocity and displacement response curve